Measurement Finder
Process analyzers, CEMS, sample handling and detection — a single instrument, or a complete turn-key system built around the brands you specify. Pick an industry, or search by what you're measuring.
Tap Point to DCS
One rep, whole chainMost analyzer problems aren't analyzer problems — they're sample problems. ISS represents every stage of the chain, so the probe, the line, the cooler, the analyzer and the shelter can be specified together as one working system rather than matched up after the fact.
Extract
Stack, flare, dilution, natural gas and distillation probes with heated filtration at the tap.
Transport
Heated sample lines holding the sample above dew point the full run to the shelter.
Condition
Coolers, chillers, coalescing filters, pumps and condensate drains — moisture out, analyte intact.
Analyze
NDIR, FID, chemiluminescence, FTIR, PAS, CRDS, mass spec, NIR, Raman, UV fluorescence, imaging.
Integrate
Shelters, cabinets, I&C, DCS/PLC/SIS tie-in, commissioning, field service and turnkey EPC.
Who We Represent
Analyzer & instrumentation linesApplication Pages
CEMS & Stack Monitoring
Interactive stack diagram — probe, heated line, opacity, mercury, multigas analysis and shelter integration.
Data Centers
Where these instruments land in a data center — cooling loop cleanliness to ASHRAE TC 9.9, glycol concentration, battery room hydrogen, generator emissions and on-site fuel gas quality.
Heat Exchangers & Oil Filtration
Kelvion heat transfer and CJC offline oil filtration — the process equipment side of the line card.
Not sure which technology fits?
Send the stream conditions — composition, temperature, pressure, and what you need to see. We'll tell you honestly whether we have the right instrument for it.